MEMORY UNIT INSTALLATION
 
The optional Memory Unit is easy to install in a matter of minutes. Please follow the below instructions carefully, in order to make the proper connections.
 
(1) Remove the small cover from the bottom of the receiver, as shown in Fig. 2.
 
(2) Connect the six plugs which are fastened to the cover to the appropriate jacks on the Memory Unit, as shown in Fig. 3.
 
(3) Mount the Memory Unit with the supplied self tapping screws (4 pcs), as shown in Fig. 4, being sure that no wire from inside the unit is protruding.
 
 
BOTTOM PANEL FEET
 
The feet on the bottom of the receiver may be changed, should you desire to change the viewing angle for the FRG-7700. The extender feet, packed in the accessory kit for the receiver, may be installed at the front or back, depending on the viewing angle desired. When repacking the receiver for shipping, be certain to replace the original feet. Refer to Figure 5 for mounting details for the bottom panel feet.
 

Figure 2
 

Figure 4
 

Figure 5